Topic

The use of patterned multiple layers of thin films of metal and dielectric to form integrated circuit interconnections of transistors and/or form on-chip circuit capacitors is well known to...

Researchers at NASA’s Marshall Space Flight Center have developed a suite of adaptable flow measurement devices that can be easily installed without compromising the structural integrity of existing conduits. With their simple installation procedures, the devices can be...

High-power electric propulsion systems have the potential to revolutionize space propulsion due to their extremely high performance. This can result in significant propellant savings on space vehicles, allowing the overall mass to shrink for launch on a less expensive vehicle, or to allow the space vehicle...

Fuel slosh is excited during spacecraft maneuvers. The forces and torques exerted on the spacecraft by the slosh must be controlled by the attitude control system to maintain correct pointing and spacecraft orbit. In some rare cases, the attitude control system may excite the slosh...

The current state-of-the-art Stirling engines use sinusoidal piston and displacer motion to drive the thermodynamic cycle and produce power. Research performed at NASA Glenn has shown that non-sinusoidal waveforms have the potential to increase Stirling engine power density, and...

This technology provides a method for interrogating collections of items with radio-frequency identification (RFID) tags. It increases the read accuracy, meaning that more of the item tags will be successfully read. It also permits smaller tag antennas than would otherwise be necessary.

Some meteorites representative of certain classes of asteroids are 25% or more water by weight. This is consistent with infrared spectra of some asteroids, indicating hydrated minerals are abundant in some varieties of carbonaceous chondrite asteroids. Since water is very valuable in space, it would...

Stirling engines typically achieve high efficiency, but lack power density. Low power density prevents them from being used in many applications where internal combustion engines are viable competitors, and increases system costs in applications that require...

NASA’s Jet Propulsion Laboratory offers a method to manufacture biomarker sensor arrays with nanoscale resolution and active regions on the order of 1 micron by applying nanolithographic direct-write techniques to the fabrication of Silane...

The use of thin-film sensors has several advantages over wire or foil sensors. For example, thin-film sensors do not require special machining of the components on which they are mounted, and, with thicknesses less than 10 μm, they are considerably thinner than wires or...