Topic

GPS radio occultation measurements are vital for climate monitoring and atmospheric temperature change detection. However, the data are irregularly distributed in space and time, which makes it inconvenient for many applications.

A proof-of-concept technique has been developed for measuring and controlling the individual phases of array elements. Electro-optic steering and beam-forming of laser beams is an emerging field with devices such as optical phased arrays that are capable of steering with significantly...

Michelle Munk is Entry, Descent and Landing Principal Investigator for the Space Technology Mission Directorate. Most recently, Munk was the subsystem lead and the Deputy Project Manager for the Mars Science Laboratory Entry, Descent, and Landing Instrumentation (MEDLI)...

The innovation provides enhanced health management routines for batteries. A mathematical model has been developed to describe battery behavior during individual discharge cycles, as well as over the cycle life. Different prognostic modes for estimating the state of charge, state of life, end of discharge,...

To reduce the cost of building specialized interfaces, missions can adopt Goddard Mission Services Evolution Center (GMSEC) technologies and applications. Assurances need to be made that application implementation should follow the GMSEC messaging standards. The GMSEC Interface...

Mass spectrometry is presented as a powerful tool for the analysis of spacecraft contamination when coupled to the Direct Analysis in Real Time (DART) ionization source. DART technology is based on soft ionization and desorption using metastable helium...

This innovation consists of a procedure and set of equations that allows thermal balance steady-state temperatures to be predicted hours before the balance is reached based on current temperature and rate-of-change measurements. This will allow tests to run...

Many control applications require precision, high-voltage-capable stimulus current drivers for sensor excitation. In particular, a requirement for a stimulus driver that can be primarily integrated into a motor feedback signal conditioning ASIC (application...

Scandate cathodes are able to produce about 20 times the emission of conventional all-tungsten cathodes at the same temperature. Conversely, they operate at about 200 °C lower temperature for the same emission. Scandate cathodes have been studied since at least the 1960s. Between...

This innovation uses an active materials-based force-amplified mechanism and advanced piezoelectric materials for more efficient energy harvesting from mechanical shock and vibration. The harvested energy is stored in rechargeable batteries. The hybrid force/stress...

Battery health monitoring is an emerging technology field that seeks to predict the remaining useful life (RUL) of battery systems before they run out of charge. Such predictive measures require interpretation of large amounts of battery status data within a Bayesian prognostic framework.

A high-rate GMSK (Gaussian Minimum Shift Keying) modulator was developed for space operation. Currently, multi-user modems are under development, and the GMSK modulator provides a way of packing more users within a space environment, especially for Mars exploration.

An improvement has been made to the infiltration of 3D woven and 3D braided preforms that will lead to the manufacture of CMC (ceramic matrix composite) and C–C (carbon-carbon) composites based on 3D fiber architectures that have low residual porosity and smaller void sizes. Tailoring the...

Magnesium fluoride (MgF2) thin films are useful for many different optics applications. In particular, they are useful for ultraviolet anti-reflective and protective coatings. However, in the far UV, one needs a very small, controllable amount of material to get the best optical performance. That is...

A new sensor substrate supports Surface Enhanced Raman Spectroscopy. A ceramic electride is demonstrated to provide surface enhanced Raman scattering. This provides a sensitive method for monitoring the chemistry and electronic environment at the electride surface. The electride, an ionic...

Multi-colored electronic displays that are dynamically reconfigurable require substantial electrical power and are limited in the amount of fine detail provided by the physical size of the light sources. For example, where phosphor elements are used, as in a television screen or computer monitor, the...

Fluid flow systems often require orifices to control pressure drop or flow rate. These orifices are often retained in bolted housings that require seals and introduce potential leak points into the system.

A hybrid mechanical/electrostatic force actuator has been developed for use in deformable mirror applications. Some deformable mirrors, designed to correct errors in optical systems, use electrostatic forces between the flexible mirror surface and a backplane to control the shape of...

Multiple Spacecraft Per Antenna (MSPA) techniques have been used for well over a decade to increase the efficient utilization of ground network assets while decreasing the antenna fees allocated to the missions. In the Deep Space Network’s traditional MSPA service, two missions...

This invention relates to the devices and methods for the measurement and/or for the specification of the perceptual intensity of a visual image, or the perceptual distance between a pair of images. Grayscale test and reference images are processed to produce test and reference luminance images. A luminance filter function...

A modified oxidation catalyst material can be used to build a carbon-monoxide-sensing electrode for amperometric sensors to overcome the typical cross-sensitivity of these sensors toward hydrogen. The technology will have applications in the emerging hydrogen fuel cell economy...