Optical Sensor Enables Continuous Noninvasive Glucose Sensing

For decades, people with diabetes have relied on finger pricks to withdraw blood or adhesive microneedles to measure and manage their glucose levels. In addition to being painful, these methods can cause itching, inflammation and infection.

Researchers at TMOS, the Australian Research Council Centre of Excellence for Transformative Meta-Optical Systems, have taken an important step towards eliminating this discomfort. Their RMIT University team has discovered new aspects of glucose’s infrared signature and have used this information to develop a miniaturized optical sensor only 5mm in diameter that could one day be used to provide continuous non-invasive glucose monitoring in diabetes management.

Noninvasive glucose sensing has been a target for almost 30 years due to its implications for pain free monitoring. Optical glucose sensing techniques have been reported; however, they require complex optical instrumentation usually found in laboratories, making them unsuitable for regular patient use.

The primary challenging facing affordable, wearable optical glucose testing has been miniaturization and filtering out the glucose signals from water absorption peaks in the near infrared (NIR) spectrum. Essentially, it has been almost impossible to accurately differentiate between water and glucose in the blood. Until now.

In first-of-its-kind research published in Advanced Sensor Research, the team has identified four infrared peaks in glucose that allow selective and sensitive identification in aqueous and biological environments. The team is keen to collaborate with academic and industry partners to continue this work and conduct preclinical and clinical research, which would open the door to the development of wearable optical glucose sensors.

The team has fabricated a miniaturized glucose sensor established on a 1600–1700 nm waveband that is Bluetooth enabled and operates using a coin battery, which allows for continuous glucose monitoring. This compact sensor has demonstrated its viability detecting glucose levels in the human body range from 50 to 400mg/dL in blood plasma, with a comparable limit of detection and sensitivity to larger, laboratory-based sensors. Its small dimensions could see it one day integrated into smart watches and other pain-free wearable health trackers.

“Until now, there is no consensus on the unique spectroscopic signature of glucose, largely because the O-H bonds targeted in near-infrared (NIR) spectroscopy for glucose detection are also abundant in water,” says RMIT PhD scholar Mingjie Yang. “This similarity makes it challenging to distinguish between glucose and water signals, especially in complex biological fluids and tissues. We optimized spectroscopy setup and analyzed transmittance to identify peaks unique to glucose. Our discovery finally provides the information necessary to move forward with miniaturized optical glucose sensing and we have developed a device prototype to suggest the foundation for futuristic non-invasive glucose sensor.”

The device prototype utilizes a surface-mounted device light emitting diode (SMD LED) and circuits made of thin-film copper coated polyamide (Cu/PI) only 110 μm thick developed with a laser patterning technology. The millimeter-scale and lightweight design of this device making it considerably more compact than traditional benchtop spectrophotometers. Furthermore, the flexible patch-like design offers the future possibility of direct reading as a wearable device on human skin.

The performance of the device has been rigorously evaluated using aqueous glucose solutions as well as in blood plasma. Computational analysis of light-skin interference has been conducted that indicate how the SMD LED will penetrate the skin. Simulation results suggest the promising locations for future exploration of optical glucose sensing in clinical setups.

“The noninvasive nature of optical glucose sensors has the potential to improve patient compliance, reduce discomfort, and lower the risks of infections associated with invasive glucose monitoring,” says Madhu Bhaskaran TMOS chief investigator. “With the right collaborators/partners and the right funding, this can represent an important shift towards continuous and pain-free glucose sensing.”

Wearable sensors, such as this one developed by TMOS researchers at RMIT, are part of center’s Meta Health Sensors Flagship Program — an applied research program dedicated to the development of meta-optical sensors for medtech applications.

RMIT University has filed a patent application related to the optical glucose sensor technology that the team developed.

This article was written by Mingjie Yang and Samara Thorn, TMOS. For more information about this research, contact This email address is being protected from spambots. You need JavaScript enabled to view it., or visit here .

---