Linköping University
Linköping, Sweden

Scientists at the Laboratory of Organic Electronics have developed an ultrasensitive heat sensor that is flexible, transparent, and printable. The results have potential for a wide range of applications including wound healing and electronic skin.

Research fellow Dan Zhao with the ultra-sensitive printed sensor (Credit: Peter Holgersson AB)

The ultrasensitive heat sensor is based on the fact that certain materials are thermoelectric. The electrons in a thermoelectric material move from the cold side to the warm side when a temperature difference arises between the two sides, and a voltage difference arises. In this present project, however, the researchers have developed a thermoelectric material that uses ions as charge carriers instead of electrons, and the effect is a hundred times larger.

A thermoelectric material that uses electrons can develop 100 μV/K (microvolt per Kelvin), which is to be compared with 10 mV/K from the new material. The signal is thus 100 times stronger, and a small temperature difference produces a strong signal.

Researchers Simone Fabiano and Dan Zhao. (Credit: Peter Holgersson AB)

The results from the research, carried out by scientists at the Laboratory of Organic Electronics at Linkoping University, Chalmers University of Technology, Stuttgart Media University, and the University of Kentucky, have been published in Nature Communications.

Dan Zhao, research fellow at Linkoping University and one of three principal authors of the article, discovered the new material, an electrolyte that consists of a gel of several ionic polymers. Some of the components are polymers of p-type, in which positively charged ions carry the current. Such polymers are well known from previous work. However, she has also found a highly conductive polymer gel of n-type, in which negatively charged ions carry the current. Very few such materials have been available until now.

First Printed Thermoelectric Module in the World

With the aid of previous results from work with electrolytes for printed electronics, the researchers have now developed the first printed thermoelectric module in the world to use ions as charge carriers. The module consists of linked n- and p-legs, where the number of leg connections determines how strong a signal is produced. The scientists have used screen printing to manufacture a highly sensitive heat sensor, based on the different and complementary polymers. The heat sensor has the ability that convert a tiny temperature difference to a strong signal: a module with 36 connected legs gives 0.333 V for a temperature difference of 1 K.

Ultra-sensitive heat sensor. (Credit: Peter Holgersson AB)

“The material is transparent, soft, and flexible and can be used in a highly sensitive product that can be printed and in this way used on large surfaces. Applications are found within wound healing, where a bandage that shows the progress of the healing process is used, and for electronic skin,” says Zhao.

In addition to Zhao, the article in Nature Communications has two further principal authors, Simone Fabiano, head of research within organic nanoelectron-ics and Xavier Crispin, professor in organic electronics, all three of whom work at the Laboratory of Organic Electronics, Campus Norrkoping.

The research has been financed by, among other sources, the Knut and Alice Wallenberg Foundation, the Tail of the Sun project, the Swedish Foundation for Strategic Research, the Swedish Research Council, and Vinnova.

This article was written by Monica Westman Svenselius, Linkoping University. Contact: Dan Zhao, This email address is being protected from spambots. You need JavaScript enabled to view it..